(Mine already was but this didn't work before I actually quick formatted it and added a clean partition.)Ģ: Unpack and put the entire DWIN_SET folder onto the SD card, nothing else.ģ: Power off and UNPLUG your printer! Flip it on its side, preferably slightly over a table edge so the top servo isn't damaged.Ĥ: Unscrew the bottom plate (6 small screws). This updates the actual screens you see, and you really need this for the new features in the TM3D firmware.ġ: Backup your SD card! It needs to be wiped and formatted as FAT 32 (MBR partition table). This should fix the issue with reverting the language, etc.įlashing the LCD. You may need USB serial drivers for this to work first, details in the TMD3D instructions above. hex file corresponding to your board (stock/silent/TM3D) variant and upload it over the USB serial connection. No SD card needed, just the USB mini cable and a computer. This is done using a slicer software or a separate flasher (I used Creality's slicer). Also see TM3D's instructions for the Ender 5 Plus (their variant and stock/silent boards) įlashing the HEX file (driver board firmware). By separately I do mean _completely_ separately, since it's its own device with its own hidden SD card slot! It is also important to note that when upgrading the firmware (official or the TM3D version) you NEED to apply the LCD upgrade separately. NOTE! Tiny Machines sell their own variant of the Ender 5 Plus with the silent board preinstalled, and what appears to be some tweaks to the Z-axis, but they do provide firmwares for other vendors - both the Stock configuration (which I have), and the Stock + a silent board. Ok, so thanks to some digging and the fine folks over at Tiny Machines 3D I figured out how to ditch this version of the firmware and switch to their version instead - which seems to include the English fix, probe offset fix, and many other goodies! This version number is based on Creality’s firmware, so if you see “Ver 1.7”, then you’re using Creality’s V1.7 firmware. ![]() You can check in the “Printer info” LCD tab under “Firmware version”.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |